Application:

Elastic and paste-like assembly adhesive producing flexible adhesive bonds. Can also be used as a sealant. Moisture-curing adhesive based on MS polymer. Free of formaldehyde, isocyanates, solvents and silicones.

Characteristics / Directions for Use:

Moisture-curing one-component adhesive with good adhesion to many substrates. Complete cure (depending on the moisture content of the substrate and the ambient air) approx. 3 mm in the first 24 hours. The adhesive cures from the outside to the inside. The cured adhesive is characterised by a very high elasticity and can also be used as a bubble-free sealant. The surfaces to be bonded have to be clean, dry and grease-free. Application is manual, with a toothed trowel (equivalent to German A2), directly from the cartridge or via a dosing unit. The processing equipment has to be completely dry. Our Application Technology Department and our Application Specialists will provide technical data to assist you in your choice of an appropriate product for your requirements. Please observe the information in the section “Remarks”. General bonding requirements The properties (e.g. surface tension, plasticiser content…) and the conditioning of the substrates, as well as the processing conditions (e.g. ambient temperature, humidity…) will influence the processes of joining and bonding. Customer tests under consideration of everyday production conditions are therefore absolutely necessary to define stable process parameters and to ensure that the product is fit for purpose. For best bonding results, the materials to be bonded should be free of dust, oil, and grease, and be dry. Ideally, the minimum temperature should be at 18 °C. Avoid draught.

Cleaning:

Before curing the prepolymer can be cleaned with a solvent-soaked rag for instance using Jowat® Thinner 401.30, after curing only mechanical removal (e.g. emery paper).

Storage:

The product should remain stored in properly closed original containers, dry and cool (15 – 25 °C). Do not transport at temperatures below +5 °C. For best-before date, please see container label. After the elapse of the best-before date, it is essential that you again verify that the product is fit for your intended application.

Packaging:

Information about other types of packaging and units is available upon request.

Remarks:

For further information concerning safety, handling, transport and disposal, please refer to the Safety Data Sheet. The information on this data sheet is based on test results from our laboratories as well as on reported experience gained in the field by our customers. It can, however, not cover all parameters for each specific application and is therefore not binding upon Jowat, nor should it be relied upon in lieu of your own required testing. The information given in this leaflet does not represent a performance guarantee. Unless otherwise agreed with our customers, the values stated in the section “Specification” shall be regarded as the finally agreed upon product properties. No liability may be derived from the information contained herein nor from the information provided by our free technical advisory service.

Please refer to the "Download" tab for the safety data sheet.